FSSI's own:  CE Approved Modified Scorpio Fire Control Panel

• Microprocessor Based

• Multiple Abort/Releasing Modes

• 14 Status Indicating LEDs

• 5 Diagnostic LEDs

• Programmable Alarm Relay

• Single or Dual Solenoid Release

• Programmable Delays

• Programmable Release Circuit Isolate

• Programmable Cross Zone Operation

• 24 Hour Trouble Resound

• Supervised Abort, Manual Release and Supervisory Circuits

• Transient and Noise Protection

 APPROVALS

• CE letter of conformity

• UL Listed to Standard 864, File #S2422

• FM Approved

• MEA Accepted MEA #339-94-E

• CSFM Listed #07165-1076:119

 GENERAL

This low cost, versatile, single hazard control panel supervises and controls one fire suppression system.  Incorporation of state of the art microprocessor technology provides increased reliability.  The control unit is compatible with KIDDE FM-200, FE-13^TM, CO₂ and IND/HDR suppression systems.  It meets requirements of NFPA 72 and is UL listed per Standard 864.   The control panel is approved for use in suppression systems covered by NFPA codes 12, 12A, 17, 17A, and 2001.  CE letter of conformity on file.

DETECTION

The control panel has two independent Style "B" initiating circuits.  A total of 15 FENWAL smoke detectors may be connected to each of these two initiating circuits.  Contact type devices such as FENWAL'S DETECT-A-FIRE heat detectors may also be connected to the same circuit.  Total lead resistance of 50 ohms allows extended detection circuit wire runs.  The unit may be programmed to activate its output functions on a single zone or two zone (cross zoned) input allowing flexibility for use in various types of applications.  See Installation, Operation and Maintenance Manual, Table 1 for UL listed compatible smoke detectors.

ALARMS

The control panel provides a single style "Y" supervised alarm output circuit for operating polarized signaling devices.  The output pulses on first alarm, and is a steady output on second alarm.  An independent form "C" dry contact is associated with each of the two alarm levels when programmed for two zone release.

The alarm silence switch located on the operator interface board will silence the alarm signal output; however, a subsequent alarm will override the alarm silence switch.

EXTINGUISHING-AGENT RELEASE

The control panel drives a control head operated release valve so the unit can be used with either the Pre-Engineered or Engineered extinguishing systems.   The release circuit will activate one 24 VDC control head (KIDDE P/N 48650001, 899175 or 890181).

For More Information Contact:

Fire Suppression Systems, Inc.
2171 Industrial Drive

Bozeman, MT  59715
Tel: (406) 586-9510
FAX: (406) 586-8701

Make Inquiry
E-mail: FireSupprn@aol.com